2004 Infiniti FX35 AWDFACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. Check Ground Connections 
    1. Turn ignition switch OFF.
    2. Loosen and retighten three ground screws on the body. See Figure. Refer to GROUND INSPECTION .

      OK or NG

      1. OK: Go to 2.
      2. NG: Repair or replace ground connections.

  2. Check Accelerator Pedal Position Sensor 1 Power Supply Circuit 
    1. Disconnect accelerator pedal position (APP) sensor harness connector. See Figure.
    2. Turn ignition ON.
    3. Check voltage between APP sensor terminal 6 and ground with CONSULT-II or tester.
      Fig 1: Confirming Reference Voltage To APP Sensor 1
      G00727233Courtesy of NISSAN MOTOR CO., U.S.A.
      1. Voltage: Approximately 5V 

      OK or NG

      1. OK: Go to 5.
      2. NG: Go to 3.

  3. Check Sensor Power Supply Circuits 

    Check the following.

    • Harness for short to power and short to ground, between the following terminals.
      TESTING APP SENSOR ECM TERMINALS

      ECM Terminal Sensor Terminal See
      48 EVAP Control System Pressure Sensor Terminal 3 WIRING DIAGRAM 
      49 Refrigerant Pressure Sensor Terminal 1 WIRING DIAGRAM 
      90 APP Sensor Terminal 6 WIRING DIAGRAM 
      91 PSP Sensor Terminal 1 WIRING DIAGRAM 
    • ECM pin terminal.

      OK or NG

      1. OK: Go to 4.
      2. NG: Repair short to ground or short to power in harness or connectors.

  4. Check Components 

    Check the following.

    • Refrigerant pressure sensor. Refer to .
    • Power steering pressure sensor. Refer to COMPONENT INSPECTION .
    • EVAP control system pressure sensor. Refer to COMPONENT INSPECTION .

      OK or NG

      1. OK: Go to 7.
      2. NG: Replace malfunctioning component.

  5. Check APP Sensor 

    Refer to COMPONENT INSPECTION .

    OK or NG

    1. OK: Go to 7.
    2. NG: Go to 6.

  6. Replace Accelerator Pedal Assembly 
    1. Replace accelerator pedal assembly.
    2. Perform ACCELERATOR PEDAL RELEASED POSITION LEARNING .
    3. Perform THROTTLE VALVE CLOSED POSITION LEARNING .
    4. Perform IDLE AIR VOLUME LEARNING .
      1. Inspection end 
  7. Check Intermittent Incident 

    Refer to TROUBLE DIAGNOSIS FOR INTERMITTENT INCIDENT .

    1. Inspection end 
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.