2003 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

Rear Window Defogger Circuit Check

  1. CHECK REAR WINDOW DEFOGGER POWER SUPPLY CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect rear window defogger connector.
    3. Turn ignition switch ON.
    4. Check voltage between rear window defogger connector and ground.
      Fig 1: Voltage Specifications Between Rear Window Defogger Connector And Ground
      G02045180Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.