2003 Infiniti Q45FACTORY OEM SERVICE PROCEDURE

Passenger Door Control Unit Circuit Check

  1. POWER SUPPLY CIRCUIT CHECK 
    1. Turn ignition switch OFF.
    2. Disconnect passenger door control unit connector.
    3. Check voltage between passenger door control unit connector D39 terminal 6 and ground.
      1. 6 (W/R) - Ground : Battery voltage 
      Fig 1: Checking Voltage Between Passenger Door Control Unit Connector D39 Terminal 6 And Ground
      G02045115Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK >> GO TO 2.
    2. NG >> Check the following.
      • 40A fusible link (letter H. located in fuse and fusible link box).
      • Harness for open or short between passenger door control unit and fuse.
  2. GROUND CIRCUIT CHECK 

    Check continuity between passenger door control unit connector D39 terminal 7 and ground.

    1. 7 (B) - Ground : Continuity should exist. 
    Fig 2: Checking Continuity Between Passenger Door Control Unit Connector D39 Terminal 7 And Ground
    G02045116Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK >> GO TO 3.
    2. NG >> Repair or replace harness.
  3. COMMUNICATION CIRCUIT CHECK 
    1. Disconnect driver door control unit connector.
    2. Check continuity between driver door control unit connector D8 terminal 5 and passenger door control unit connector D38 terminal 11.
      1. 5 (G/OR) - 11 (G/OR) : Continuity should exist. 
      Fig 3: Checking Continuity Between Driver Door Control Unit Connector D8 Terminal 5 And Passenger Door Control Unit Connector D38 Terminal 11
      G02045117Courtesy of NISSAN MOTOR CO., U.S.A.

    OK or NG 

    1. OK >> INSPECTION END.
    2. NG >> Repair or replace harness between door control unit and passenger door control unit.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.