2003 Infiniti M45FACTORY OEM SERVICE PROCEDURE

Work Flow

NOTE: For diagnostic procedure 1, see DIAGNOSTIC PROCEDURE 1, CHECK "L" TERMINAL CIRCUIT  , diagnostic procedure 2, see DIAGNOSTIC PROCEDURE 2, CHECK "B" TERMINAL CIRCUIT  , for diagnostic procedure 3, see DIAGNOSTIC PROCEDURE 3, CHECK "L" TERMINAL CIRCUIT  , for diagnostic procedure 4, see DIAGNOSTIC PROCEDURE 4, CHECK "B" TERMINAL CIRCUIT  and for diagnostic procedure 5, see DIAGNOSTIC PROCEDURE 5, CHECK "S" TERMINAL CIRCUIT  .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.