2003 Infiniti I35FACTORY OEM SERVICE PROCEDURE

KEYFOB Battery And Function Check

  1. CHECK KEYFOB BATTERY 
    NOTE: Keyfob does not function if battery is not set correctly.

    Remove battery and measure voltage across battery positive and negative terminals, (+) and (-).

    1. Voltage [V]: 
      1. 2.5 - 3.0 
        Fig 1: Checking Keyfob Battery
        G02092539Courtesy of NISSAN MOTOR CO., U.S.A.
    1. OK or NG 

    OK GO TO 2.

    NG Replace battery.

  2. CHECK KEYFOB FUNCTION 

    With CONSULT-II 

    Check keyfob function ("LK BUTTON/SIG", "UN BUTTON/SIG", "TRUNK BTN/SIG", "PANIC BTN", "UN BUTTON ON" and "LK/UN BTN ON") in "DATA MONITOR" mode with CONSULT-II.

    Fig 2: Checking Keyfob Function
    G02092540Courtesy of NISSAN MOTOR CO., U.S.A.
    1. OK or NG 

    OK Keyfob is OK. Further inspection is necessary. Refer to "SYMPTOM CHART  ".

    NG Replace keyfob. Refer to ID Code Entry Procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.