2003 Infiniti FX45FACTORY OEM SERVICE PROCEDURE

Diagnostic Procedure

  1. If using CONSULT-II, go to next step. If using generic scan tool, go to step Β 3 .
  2. Turn ignition on. Select SELF-DIAG RESULTS mode with CONSULT-II. Press ERASE. Perform DTC CONFIRMATION TEST "A"Β  again. If 1st trip DTC is detected, go to step Β 4 . If 1st trip DTC is not detected, test is complete.
  3. Turn ignition on. Select MODE 4 with scan tool. Press ERASE. Perform DTC CONFIRMATION TEST "A"Β  again. If 1st trip DTC is detected, go to next step. If 1st trip DTC is not detected, test is complete.
  4. Replace ECM.
  5. Perform initialization of NATS system and registration of all NATS ignition key IDs.
  6. Perform accelerator pedal released position learning. See ACCELERATOR PEDAL RELEASED POSITION LEARNINGΒ  under PROGRAMMING. Perform throttle valve closed position learning. See THROTTLE VALVE CLOSED POSITION LEARNINGΒ  under PROGRAMMING. Perform idle air volume learning. See IDLE AIR VOLUME LEARNINGΒ  under PROGRAMMING.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.