Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Infiniti FX35 RWDFACTORY OEM SERVICE PROCEDURE
Idle Air Volume Learning: Preparation
Before performing Idle Air Volume Learning, ensure that all of the following conditions are satisfied. Learning will be cancelled if any of the following conditions are missed for even a moment:
- Battery voltage - More than 12.9 volts at idle.
- Engine coolant temperature - 158-212°F (70-100°C).
- PNP switch - ON.
- Electric load switch - OFF (air conditioner, headlight, rear window defogger).
- On vehicles equipped with daytime light systems, set lighting switch to the first position to light only small lights.
- Steering wheel - Neutral (straight-ahead position).
- Vehicle speed - Stopped.
- Transmission - Warmed-up.
- For models with CONSULT II, drive vehicle until FLUID TEMP SE in DATA MONITOR mode of A/T system indicates less than 0.9 volt.
- For models without CONSULT-II, drive vehicle for 10 minutes.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.