Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Catalytic Converter Codes
For test purposes ensure ambient temperature is 20-95°F (-7-35°C).
- Connect scan tool to DLC. Start engine and hold at 3000 RPM with no load until radiator fan comes on.
- Drive vehicle for about 10 minutes, without stopping. Preferably on highway where speed can be varied.
- With A/T in "D" position, M/T in 5th gear, drive at steady speed between 50 and 62 MPH for 30 seconds.
- Repeat step 4 three times. Between each repetition, close throttle completely for 1-2 seconds. If engine is stalls or is shut off during this part of procedure, repeat procedure starting in step 2.
- Readiness code should now be set. Use scan tool to check readiness code.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.