Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Infiniti I35FACTORY OEM SERVICE PROCEDURE
Retained Power Function Inoperative
Check the following in order listed and repair as necessary:
- Check Purple wire for open and/or short circuit between terminal No. 2 on power window relay and Smart Entrance Control Unit (SECU).
- Check for battery voltage at terminal No. 46 (Purple wire) on SECU connector within 45 seconds of turning ignition key to OFF position. Ensure all doors are closed.
- Check continuity of power window switches ground circuits.
- Inspect all power window switches.
- Replace SECU.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
