Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
DTC Confirmation Test
Malfunction is detected when ECM receives improper voltage signal from FPCM. Possible causes are:
- FPCM circuit open or shorted.
- Defective dropping resistor.
- Defective FPCM.
To set DTC, turn ignition on. Select DATA MONITOR with scan tool. Start engine. Ensure TCS switch is in OFF position. Shift transmission into Drive. Drive vehicle at a speed of 43-62 MPH for 12 seconds.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.