2000 Infiniti QX4FACTORY OEM SERVICE PROCEDURE

Ignition Coil Resistance

  1. Carefully inspect external housing for burned spots indicating secondary circuit arcing to primary or ground circuits. Disconnect ignition coil primary 2-pin harness connector. Measure resistance between primary connector terminals.
  2. Measure resistance between secondary tower and positive terminal of coil primary connector. Positive terminal is identified by wire color. See IGNITION COIL POWER SOURCE TERMINAL IDENTIFICATIONΒ  table. If either resistance is not as specified, replace ignition coil. See appropriate IGNITION COIL RESISTANCE table.
IGNITION COIL RESISTANCE (EXCEPT SENTRA) - OHMS @ 68Β°F (20Β°C)

Application Primary Secondary
Maxima (1) (1)
Except Maxima 1.0 10,000
(1) Information is not available from manufacturer.
IGNITION COIL RESISTANCE (SENTRA) - OHMS @ 77Β°F (25Β°C)

Application Primary Secondary
1.8L (1) (1)
2.0L .8 16,000
(1) Information is not available from manufacturer.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.