Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Infiniti QX4FACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| ABS Control Unit/Actuator Bracket Bolts | 13-17 (18-24) | ||
| ABS Control Unit/Actuator Mounting Nuts | (1) | ||
| Hydraulic Brakelines At Actuator | 11-13 (15-18) | ||
| Wheel Lug Nuts | 87-108 (118-147) | ||
| Wheel Speed Sensor Mounting Bolt (Front) | 8-11 (11-15) | ||
| Wheel Speed Sensor Mounting Bolt (Rear) | 13-17 (18-24) | ||
| INCH Lbs. (N.m) | |||
| "G" Sensor Mounting Bolts | (1) | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.