Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition Coil Resistance
Ignition coil is located in distributor. Disconnect distributor 2-pin harness connector. Remove distributor cap. Measure resistance between distributor 2-pin connector terminals. Also measure resistance between ignition coil tower and distributor 2-pin connector terminal No. 8. See Fig 1 . See IGNITION COIL RESISTANCE table.
| Application | Resistance @ 77°F (25°C) | ||||
|---|---|---|---|---|---|
| Primary (1) | About 0.8 Ohm | ||||
| Secondary (2) | About 16K/Ohms | ||||
|
|||||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
