2000 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

A/C Switch

Informs ECM when A/C system is on. ECM responds by increasing idle speed to improve idling and reduce emissions. On G20, ECM will open the A/C clutch relay to disengage A/C clutch during Wide Open Throttle (WOT), cranking, high engine speeds, when engine coolant temperature is high, when operating power steering during low engine speed or low vehicle speed and when engine speed is excessively low. On Q45, ECM will open the A/C clutch relay to disengage A/C clutch during Wide Open Throttle (WOT), cranking, high engine speeds and when Traction Control System (TCS) is operating.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.