2000 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

Body Control Module (BCM)

Turn ignition switch to LOCK position. Disconnect BCM harness connector. Check for continuity between ground and terminals No. 56 (Black wire) and No. 113 (Black wire) at BCM harness connector. See Figure . If continuity exists, ground circuit is currently okay. If continuity does not exist, repair open in Black wire between BCM and ground.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.