2000 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

Clearing Codes Using Scan Tool

Turn ignition switch to LOCK position. Connect Nissan's CONSULT scan tool to Data Link Connector (DLC). Turn ignition switch to ON position. Touch START, then IVMS on scan tool display. Touch IVMS COMM CHECK, then IVMS COMM DIAGNOSIS, and then touch START on scan tool display. To erase detected failures, touch ERASE on scan tool display. Repeat LAN COMMUNICATIONS CHECKΒ  to ensure repairs are complete.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.