Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Infiniti I30 Base, RE4F04BFACTORY OEM SERVICE PROCEDURE
Final Procedure
NOTE:
If no DTCs exist and SCS is connected, MIL will stay illuminated with ignition on.
This procedure must be performed after any trouble shooting. Remove Service Check Connector (SCS) connector, if connected. Perform ECM/PCM reset procedure. Turn ignition off. Disconnect scan tool.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.