Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Infiniti I30 Base, RE4F04BFACTORY OEM SERVICE PROCEDURE
DTC P1220: Fuel Pump Control Module (FPCM): Notes
NOTE:
Using the following diagnostic procedure assumes the presence of a current (hard) DTC or the ability to duplicate the setting of the DTC using DTC confirmation test(s), intermittent recreation procedures or a test drive under conditions stored in freeze frame data. See TESTING PROCEDURE
under SELF-DIAGNOSTIC SYSTEM in SELF-DIAGNOSTICS - INTRODUCTION article. If DTC cannot be duplicated, proceed to TROUBLE SHOOTING - NO CODES
article for diagnosis by symptom.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.