2000 Infiniti G20 Base, Automatic, RE4F03WFACTORY OEM SERVICE PROCEDURE

Horn Reminder Check

  1. Inspect horn system. Press horn button. If horn sounds, go to next step. If horn does not sound, inspect and repair horn system. See WIRING DIAGRAMSΒ  .
  2. Ensure ignition switch to OFF position. Disconnect Smart Entrance Control Unit (SECU) 24-pin connector and apply ground to terminal No. 19 (Green/White wire). See Figure . If horn does not sound, inspect Green/White wire between horn relay and SECU for open or short. If horn sounds, replace SECU.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.