1999 Infiniti QX4FACTORY OEM SERVICE PROCEDURE

Interior Light Function Inoperative

NOTE: If no problem exists after performing tests, replace remote controller. When remote controller is replaced, all remote controllers that are to be used with this system must be reprogrammed at the same time. See PROGRAMMINGΒ  .

Ensure interior light switch is in DOOR position. If dome light illuminates when a door is opened, but not when pressing unlock button on remote controller, perform INTERIOR LIGHT OPERATION CHECKΒ  under SYSTEM TESTS. If dome light does not illuminate at all, check interior light circuit. See appropriate wiring diagram in ILLUMINATION/INTERIOR LIGHTS article.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.