1999 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

Erasing Stored Information

NOTE: Test modes cannot be switched with engine running. When ignition is turned off, power to PCM will turn off after 5 seconds. PCM will then return to diagnostic test mode I. Ensure test mode selector is in fully counterclockwise position when vehicle is in use.

The following emission related information will be erased from PCM memory: DTCs stored, 1st trip DTCs, freeze frame data, 1st trip freeze frame data, System Readiness Test (SRT) codes and test values. To erase this information, switch from diagnostic test mode II to diagnostic test mode I. While PCM is in diagnostic test mode II, turn mode selector on PCM fully clockwise, wait 2 seconds and turn mode selector fully counterclockwise.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.