Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Diagnostic Test Mode II
Turn ignition on, but leave engine off. Using a small screwdriver, turn diagnostic mode selector on PCM fully clockwise and MIL should turn off. Wait at least 2 seconds, and then turn diagnostic mode selector fully counterclockwise which will enter into diagnostic test mode II. MIL will flash any DTC(s) present. If 2 or more DTCs are displayed, they may be DTC's or 1st trip DTCs. These can be identified by using CONSULT or GST. To erase stored diagnostic information, go to ERASING STORED INFORMATION .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.