1999 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

Freeze-Frame Data

NOTE: 1st trip freeze-frame data values can only be displayed with Nissan's CONSULT, and are not displayed on GST scan tool.

Freeze-frame data is a "snapshot" of the operating conditions present when a fault is detected by PCM. When a fault is detected for the first time, PCM stores the first trip DTC, along with first trip freeze-frame data. Only one set of freeze-frame data can be stored in PCM (either first trip freeze-frame data or freeze-frame data). There is no priority for first trip freeze frame data. It is updated each time a different first trip DTC is stored. If a fault is detected for the second time, first trip freeze-frame data is replaced with freeze-frame data.

Freeze-frame data is updated in order of priority. See FREEZE FRAME PRIORITY IDENTIFICATIONΒ  table. If a priority 1 fault (misfire or fuel injection system malfunction) is detected in another trip when priority 2 freeze-frame data is already stored in PCM, priority 2 freeze-frame data will be replaced by priority 1 freeze-frame data.

NOTE: Only one 1st trip DTC and one freeze-frame data "snapshot" can be stored in PCM. If using GST, 1st trip DTC freeze-frame information may not be accessible. Use CONSULT to retrieve 1st trip DTC freeze-frame information.
FREEZE FRAME PRIORITY IDENTIFICATION

Priority Items
1 Freeze Frame Data For Misfire DTC P0300-P0308, Fuel Injection System DTC P0171, P0172
2 (1) 2nd Trip Freeze Frame Data
3 1st Trip Freeze Frame Data
(1) Not in priority 1.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.