1999 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

Distributor Sensors

CRANKSHAFT POSITION SENSOR

Application Resistance (Ohms)
G20 166-204 @ 77°F (25°C)
I30 (1)
Q45 166.5-203.5 @ 68°F (20°C)
(1) With screwdriver contacting sensor core, voltage output should be 5 volts. When screwdriver is removed, voltage output should be zero volts.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.