1998 Infiniti QX4FACTORY OEM SERVICE PROCEDURE

Ignition Coil Power Source

  1. Disconnect ignition coil 2-pin harness connector. Turn ignition on. Check for voltage at appropriate wire at ignition coil harness connector. See IGNITION COIL POWER SOURCE TERMINAL IDENTIFICATIONΒ  table.
  2. If voltage is present, check ignition coil resistance. See appropriate IGNITION COIL RESISTANCE table. If voltage is not present, check continuity of entire circuit between battery and ignition coil, including fusible link and ignition switch. See POWER DISTRIBUTION section in SYSTEM WIRING DIAGRAMS article.
IGNITION COIL POWER SOURCE TERMINAL IDENTIFICATION

Application Wire Color
Altima Black/Red
Frontier, Pathfinder & QX4 Black/White
Maxima Red
Quest Brown
Sentra & 200SX
1.6L Black/White
2.0L Black/Red
240SX Black/Red
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.