1998 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

With Nissan CONSULT Scan Tool

  1. Turn ignition off. Connect Nissan CONSULT to Data Link Connector (DLC). DLC is located under instrument panel next to parking brake release handle. Turn ignition on. Touch START, IVMS, then REMOTE CONT ID REG on scan tool display. Touch START on scan tool display. Original ID code(s) are erased and power door locks will lock, unlock and hazard warning lights will flash twice.
  2. Push lock button on remote controller once. ID code for new remote controller has now been entered. Power door locks will lock, unlock and hazard warning lights will flash twice to confirm.
  3. Repeat step Β 2 to enter additional remote controller ID codes. A maximum of 4 remote controller ID codes can be entered. If same ID code is entered more than once, the entry is ignored. After programming all remote controllers to be used with system, touch END on scan tool display.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.