Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS
| Component | Component Location |
|---|---|
| ABS/TCS Control Unit | Behind right side of dash. See Figure . |
| A/C Control Unit | Behind center of dash. |
| Air Bag Diagnosis Sensor Unit | Under console, behind parking brake lever. See Figure . |
| A/T Control Unit | Behind left kick panel. See Figure . |
| ASCD Control Unit | Behind dash, left of steering column. See Figure . |
| Body Control Module (BCM) | In dash, behind dash meter. See Figure . |
| Daytime Lamp Control Unit (Canada) | Left side of engine compartment. See Figure . |
| Driver's Door Control Unit | In driver's door. |
| Driver's Seat Control Unit | Under driver's seat. See Figure . |
| ECM (ECCS Control Module) | Behind right kick panel. See Figure . |
| Fuel Pump Control Module (FPCM) | On left side of luggage compartment. See Figure . |
| NATS IMMU | Under front of center console. See Figure . |
| Passenger's Door Control Unit | In passenger front door. |
| Power Steering Control Unit | Behind dash, right of steering column. See Figure . |
| Rear Left & Right Door Control Units | In each respective rear door. |
| Shift Lock Control Unit | Behind left side of dash. See Figure . |
| TAC Module | Behind right side of dash, above kick panel. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
