Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Infiniti J30 BaseFACTORY OEM SERVICE PROCEDURE
Fuel Pump
- Remove fuel tank filler cap. Turn ignition on. Listen for fuel pump operating noise. If noise is not present, check fuel pump relay and wiring harness between relay and pump. If no faults are found, check fuel pump control module. See DTC P1220: FUEL PUMP CONTROL MODULE (FPCM) in appropriate TESTS W/CODES article.
- If fuel pump control is okay, disconnect fuel pump/sending unit connector at fuel tank. Check resistance between terminals No. 1 and 3. See Fig 1 . On all models, at 68°F (20°C), ohmmeter should indicate less than 5 ohms. If resistance is not correct, replace fuel pump.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.