1997 Infiniti J30 BaseFACTORY OEM SERVICE PROCEDURE

Programming Remote Controller

  1. New Identity (ID) code must be manually entered whenever replacing or adding additional remote controller(s). To enter ID code, perform steps 2) and 3).
  2. Open trunk lid. Close and lock all doors. Erase original ID code(s) by inserting and removing key from ignition switch more than 6 times within 10 seconds.
  3. Unlock and lock driver's door inside lock lever once. Push lock button on new remote controller once. ID code for new remote controller has now been entered.
  4. Repeat steps 2) and 3) to enter additional remote controller ID code(s). A maximum of 4 remote controller ID codes can be entered. If same ID code is entered more than once, the entry is ignored. To exit programming (ID entry) mode, open any door.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.