1996 Infiniti J30 tFACTORY OEM SERVICE PROCEDURE

Fuel Pump Control Module

Start engine and warm to operating temperature. Using a DVOM, backprobe between Blue and Black wire terminals of fuel pump control module. For 30 seconds after starting engine, voltmeter should read zero volts. After 30 seconds of starting engine, voltmeter should read 4.2 volts. Replace module if voltage is not as specified.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.