Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1996 Infiniti J30 tFACTORY OEM SERVICE PROCEDURE
Fuel Control: Notes
ECM controls fuel system based upon sensor input signals. If feedback system does not function properly, check input signals before replacing ECM.
FUEL CONTROL SYSTEM INPUT SIGNALS
| Application | Model Usage |
|---|---|
| Battery Voltage | J30 |
| Closed Throttle Position Switch | J30 |
| Crankshaft Position Sensor | J30 |
| EGR Temperature Sensor | J30 |
| Engine Coolant Temperature | J30 |
| Heated Oxygen Sensor | J30 |
| Ignition (START) Signal | J30 |
| Mass Airflow Sensor | J30 |
| Park/Neutral Switch | J30 |
| Power Steering Pressure Switch | J30 |
| Throttle Position Sensor | J30 |
| Vehicle Speed Sensor | J30 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
