1996 Infiniti J30 BaseFACTORY OEM SERVICE PROCEDURE

ID Code Entry

  1. Open trunk. Close and lock all doors. Insert and remove key from ignition switch more than 6 times in less than 10 seconds. Using driver's door lock lever, unlock, then lock driver's door once. Press lock button on controller once to enter code.
  2. A maximum of 4 codes can be entered in succession. Unlock, then lock driver's door with door lock lever before entering each code. ID code entry enable state will exist until any door is opened.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.