1995 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

DTC 32: EGR Function

  1. Check Vacuum Source To EGR Valve

    Start engine and bring to operating temperature. Perform Diagnostic Test Mode II (Self-Diagnostic Results) ensuring DTC 11 and DTC 12 are not displayed. With engine speed at about 2000 RPM, disconnect vacuum hose to EGR valve. See Fig 1 and Fig 2 . If vacuum is not present, go to next step. If vacuum is present, inspect EGR valve and EGRC backpressure transducer valve. See I - SYSTEM/COMPONENT TESTS article. Replace EGR valve and/or EGRC backpressure transducer valve if necessary and perform FINAL CHECKΒ  .
  2. Check Control Function

    If vacuum is not present, with engine running, measure voltage between ECM terminal No. 102 (Blue/Red wire) and ground. At idle, voltage should be approximately zero volts. At 2000 RPM, voltage should be battery voltage. See Fig 3 . If voltage measured is not as specified, go to step 4). If voltage is as specified, inspect vacuum hose for clogging, cracks or proper connection. Repair or replace vacuum hose as necessary.
  3. Check Control Function Using CONSULT

    If vacuum is not present, turn ignition off. Connect CONSULT and turn ignition on. Perform EGRC SOL/V CIRCUIT in FUNCTION TEST mode. Another method is to use CONSULT to turn EGRC solenoid valve ON and OFF in ACTIVE TEST mode and check for operating sounds. If EGRC solenoid valve is okay, inspect vacuum hose for clogging, cracks or proper connection. Repair or replace vacuum hose as necessary.
  4. Check Output Signal Circuit

    Turn engine off and disconnect ECM harness connector. Disconnect EGRC solenoid valve harness connector. Verify harness continuity between ECM terminal No. 102 (Blue/Red wire) and ground, and between EGRC solenoid valve harness connector terminal "b" (Blue/Red wire) and ground. See Fig 4 . If continuity does not exist, go to next step. If there is continuity, repair harness or connectors between ECM and EGRC solenoid valve, as necessary.
  5. Check Component

    Inspect EGRC solenoid valve. See I - SYSTEM/COMPONENT TESTS article. Replace EGR control solenoid valve if necessary. If EGRC solenoid valve is okay, inspect EGR temperature sensor resistance. See I - SYSTEM/COMPONENT TESTS article. Replace EGR temperature sensor if necessary and perform FINAL CHECKΒ  .
Fig 1: Locating EGR Control Solenoid Valve Harness Connector (Q45)
G94G44152Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.