1995 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

NISSAN Consult Diagnostics: Notes

NOTE: While in diagnostic mode using Nissan CONSULT, LAN-controlled electrical systems operate as follows. See ELECTRICAL SYSTEM DIAGNOSTIC MODE OPERATIONS table.
ELECTRICAL SYSTEM DIAGNOSTIC MODE OPERATIONS

Application Condition
Power Window Control
Main Switch Does Not Operate
Lock Switch Does Not Operate
Sub-Switch (1) Operates
AUTO Operation (2) Does Not Operate
Power Door Lock Control Does Not Operate
Automatic Drive Positioner Control
Automatic Operation Does Not Operate
Cancel Switch, Set Switch & Memory Switches (1 & 2) Does Not Operate
Manual Operation Operates
Power Seat Control
Passenger Seat (3) Operates
Time Control System
Intermittent Wiper Control Does Not Operate
Rear Window Defogger Timer Control Does Not Operate
Ignition Key Warning Control Does Not Operate
Light Warning Control Does Not Operate
Interior Light Control Does Not Operate
Seat Belt Timer Control Does Not Operate
Door Key Hole Illumination Control Does Not Operate
Theft Warning Control Does Not Operate
Step Light Control Does Not Operate
Illumination Control Does Not Operate
Door Mirror Automatic
Tilt Down Reverse Control Does Not Operate
Multi-Remote Control Does Not Operate
(1) Operates even when ignition is off.
(2) Driver's seat only.
(3) Does not operate during ACTIVE TEST mode.
NOTE: Limited information on Nissan CONSULT is available. For additional information, refer to Nissan CONSULT operation manual.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.