1995 Infiniti G20 Automatic, 1RL4F03VFACTORY OEM SERVICE PROCEDURE

Timing Advance System

ECM controls ignition timing advance based upon sensor input signals that reflect ignition timing needs. If timing problems are experienced, inspect input signals for proper operation. See TIMING ADVANCE SYSTEM INPUT SIGNALS table. To check input signals, see ENGINE SENSORS & SWITCHES or ECM pin voltage charts in PIN VOLTAGE CHARTS article.

TIMING ADVANCE SYSTEM INPUT SIGNALS

Application Model Usage
Battery Voltage G20
Crankshaft Position Sensor G20
Engine (Coolant) Temperature G20
Ignition (START) Signal G20
Mass Airflow Sensor G20
Park/Neutral (Inhibitor) Switch G20
Throttle Position Sensor G20
Vehicle Speed Sensor G20
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.