1995 Infiniti G20 Automatic, 1RL4F03VFACTORY OEM SERVICE PROCEDURE

Fuel Control: Notes

ECM controls fuel system based upon sensor input signals. See FUEL CONTROL SYSTEM INPUT SIGNALS table. If feedback system does not function properly, check input signals before replacing ECM.

FUEL CONTROL SYSTEM INPUT SIGNALS

Application Model Usage
A/C Clutch Signal G20
Battery Voltage G20
Crankshaft Position Sensor G20
EGR Temperature Sensor G20
Engine (Coolant) Temperature G20
Heated Oxygen Sensor G20
Ignition (START) Signal G20
Mass Airflow Sensor G20
Neutral Switch (1) G20
Park/Neutral (Inhibitor) Switch G20
Power Steering Pressure Switch G20
Throttle Position Sensor G20
Vehicle Speed Sensor G20
(1) M/T models only.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.