Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE
Wheel Alignment Specifications
WHEEL ALIGNMENT SPECIFICATIONS
| Application | Preferred | Range | ||||||
|---|---|---|---|---|---|---|---|---|
| With Active Suspension | ||||||||
| Camber (1) | ||||||||
| Front | -0.92 | -1.67 To -0.17 | ||||||
| Rear | -1.5 | -2 To -1 | ||||||
| Caster | ||||||||
| Front (1) | 6.92 | 6.17 To 7.67 | ||||||
| Toe-In (2) | ||||||||
| Front | 0 | -0.04 To 0.04 | ||||||
| Rear | 0.08 | 0 To 0.16 | ||||||
| Toe-In (1) | ||||||||
| Front | 0 | -0.08 To 0.08 | ||||||
| Rear | 0.18 | 0 To 0.36 | ||||||
| Toe-Out On Turns (1) | ||||||||
| Inner | 37 | 35 To 39 | ||||||
| Outer | 32 | N/A | ||||||
| SAI (1) | 12.92 | N/A | ||||||
| W/O Active Suspension | ||||||||
| Camber (1) | ||||||||
| Front | -0.83 | -1.58 To -0.08 | ||||||
| Rear | -1.08 | -1.58 To -0.58 | ||||||
| Caster (1) | ||||||||
| Front | 6.5 | 5.75 To 7.25 | ||||||
| Toe-In (2) | ||||||||
| Front | 0.04 | 0 To 0.08 | ||||||
| Rear | 0.08 | 0 To 0.16 | ||||||
| Toe-In (1) | ||||||||
| Front | 0.08 | 0 To 0.16 | ||||||
| Rear | 0.18 | 0 To 0.36 | ||||||
| Toe-Out On Turns (1) | ||||||||
| Inner | 37.5 | 35.5 To 39.5 | ||||||
| Outer | 32 | N/A | ||||||
| SAI (1) | 12.75 | N/A | ||||||
|
||||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.