Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE
Engine Won't Start
- If engine cranks abnormally or slowly, go to step 6). If engine does not crank, ensure starter turns. If starter does not turn, go to next step. If starter turns, ensure gear shaft turns. If gear shaft does not turn, check reduction gear, armature and gear shaft for damage, and replace as necessary. If gear shaft turns, check pinion clutch for damage, and replace as necessary.
- If starter does not turn, check fuse and fusible link. Replace as necessary. If fuse and fusible link are okay, check battery for proper charge. Charge as necessary. Check battery terminals for corrosion and looseness. Service as necessary.
- If battery charge and terminals are okay, check starter system components and wiring. Repair wiring or replace ignition switch, inhibitor switch or starter relay as necessary.
- If starter components and wiring are okay, ensure starter solenoid movement is heard. If starter solenoid movement cannot be heard, replace solenoid. If starter solenoid movement can be heard, ensure pinion and ring gear mesh properly. If pinion and ring gear do not mesh properly, adjust pinion extension length. See PINION EXTENSION LENGTHΒ under BENCH TESTING.
- Check shift lever for defects. Check return springs and pinion for sliding condition. Replace as necessary. If pinion and ring gear mesh properly, remove starter from engine. Ensure starter turns under no-load condition. If starter does not turn, disassemble starter, and check components. If starter turns, check starter solenoid, and replace as necessary.
- Check battery charge. Check terminals for looseness and corrosion. Service as necessary. Check starter draw while cranking. If starter draw is excessive, repair or replace starter as necessary. If engine continues to crank abnormally, check engine for mechanical faults.
- If starter will not stop turning when ignition is turned off, repair or replace ignition switch, starter relay (if equipped) or starter solenoid.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
