1994 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

Pinion Extension Length

  1. Disconnect "M" terminal lead from solenoid. Energize solenoid. Push pinion back by hand to remove slack, and measure distance between pinion and pinion stopper. See Fig 1 .
  2. Clearance should be .020-.079" (.5-2.0 mm). If measurement is not as specified, remove solenoid, and install appropriate adjusting plate between solenoid and starter housing. Adjusting plates come in 2 thicknesses, .020" (.5 mm) and .031" (.8 mm).
Fig 1: Checking Starter Pinion Extension Clearance (Q45)
G92B00241Courtesy of NISSAN MOTOR CO., U.S.A.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.