Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1994 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE
Armature Test
- Check continuity between 2 side-by-side commutator bars. Check each segment the same way. If no continuity exists, replace armature. Check for continuity between each commutator bar and armature shaft. If continuity exists, replace armature.
- If commutator surface is rough, sand lightly using No. 500 or 600 grit sandpaper. Using a micrometer or vernier caliper, measure commutator diameter. If commutator diameter is not within specification, replace armature. See MINIMUM COMMUTATOR DIAMETERΒ table.
- Check depth of insulating mold between commutator bars. If depth is less than .008" (.2 mm), using a hacksaw blade or file, undercut to .020-.031" (.5-.8 mm).
MINIMUM COMMUTATOR DIAMETER
| Application | In. (mm) |
|---|---|
| Q45 | 1.134 (28.8) |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
