1994 Infiniti G20 Automatic, 1RL4F03VFACTORY OEM SERVICE PROCEDURE

System Test

  1. Start engine, and warm to operating temperature. Check Idle speed. If idle speed is excessive, disconnect IACV-AAC valve harness connector, idle speed should drop. If idle speed does not drop, check for battery voltage at IACV-AAC connector terminal "A" (Gray wire). If battery voltage is present, go to next step. If battery voltage is not present, check fuses and harness for open circuit.
  2. Turn ignition off. Disconnect ECM harness Connector. Check harness continuity between IACV-AAC connector terminal "B" (Light Blue wire) and ECM (terminal No. 113). Continuity should exist. If continuity does not exist, repair wiring as necessary.
  3. If harness tests okay, test IACV-AAC valve and inspect ECM connector terminal pins.
IDLE SPEED SYSTEM INPUT SIGNALS

Application Model Usage
A/C Clutch Signal G20
Battery Voltage G20
Crankshaft Position Sensor G20
Engine (Coolant) Temperature G20
Ignition (START) Signal G20
Neutral Switch (1) G20
Park/Neutral (Inhibitor) Switch G20
Power Steering Pressure Switch G20
Throttle Position Sensor G20
Vehicle Speed Sensor G20
(1) M/T models only.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.