Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1993 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE
DTC 16: Traction Control System (TCS) Signal
- Check Input Signal Circuit - Turn ignition off. Disconnect ECM harness connector and Traction Control Module (TCM) 20-pin harness connector. Check harness continuity between ECM terminal No. 36 and TCM terminal No. 7 (Red/Green wire). See Fig 1 and Fig 2 . If continuity is present, go to next step. If continuity is not present, verify harness and connector continuity between ECM and TCM. Repair harness or connectors as necessary.
- Check Component - Inspect TCS function. See TRACTION CONTROL SYSTEM article in the BRAKES section. Replace TCS component(s) if necessary and perform FINAL CHECK.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
