Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Lower Steering Shaft Joint Bolt | 17-22 (24-29) | |
| Lower Column Bracket Nut | ||
| G20 | 11-14 (15-19) | |
| Q45 | 9-13 (13-18) | |
| Steering Wheel Nut | 22-29 (29-39) | |
| Tilt Wheel Adjusting Nut (M30) | ||
| On Column | 13-20 (18-27) | |
| On Tilt Lever | 17-22 (24-29) | |
| Upper Column Bracket Bolts | ||
| G20 & M30 | 9-13 (13-18) | |
| Q45 | 12-15 (16-21) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.