Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE
Steering Column: Adjustments: Notes
WARNING:
M30 and Q45 are equipped with Supplemental Restraint System (SRS). Observe following precautions before performing any repair. Disconnect and shield battery ground. Disconnect SRS connector at control unit located behind center console. All SRS wiring harnesses and connectors are Yellow. DO NOT use electrical test equipment on these circuits. Use caution when working around steering column as air bag could deploy.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.