1992 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

4-Cylinder Ignition Timing: G20

  1. Start engine, and warm it to normal operating temperature (needle is in middle of coolant gauge). Operate engine for 2 minutes at 2000 RPM. Perform self-diagnostic procedure, and check for smooth engine operation. See G - TESTS W/ CODES article in the ENGINE PERFORMANCE Section.
  2. Turn engine off. Disconnect throttle position sensor connector, and restart engine. Increase engine speed to 2000 RPM, 2 or 3 times, and then allow engine to return to idle.
  3. Connect timing light to cylinder No. 1 spark plug cable. Check ignition timing. See IGNITION TIMINGΒ  table. If necessary, adjust timing by loosening distributor mounting bolts and turning distributor. With ignition timing correctly set, check idle speed and mixture. See IDLE SPEED & MIXTURE. Reconnect throttle position sensor connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.