1992 Infiniti Q45 BaseFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
ABS Control Unit Under right side of dash, above glove compartment. See Figure .
Active Suspension Control Unit Under right rear package tray. See Figure .
A/T Control Unit Behind left kick panel. See Figure .
Automatic Drive Positioner Control Unit Behind left side of dash. See Figure .
Automatic Speed Control Device (ASCD) Control Unit Behind dash, right of steering column. See Figure .
ECCS Control Unit Behind right kick panel. See Figure .
Fuel Pump Control Unit Under center of rear package tray. See Figure .
Power Seat Control Unit Underneath each front seat. See Figure .
Power Steering Control Unit Behind dash, right of steering column. See Figure .
Shift Lock Control Unit Behind left kick panel. See Figure .
Supplemental Restraint System (SRS) Control Unit Under console, behind parking brake lever. See Figure .
Theft Warning Control Unit
View of Passenger Compartment Behind right side of dash, above glove compartment. See Figure .
View of Component Parts & Connector Behind right side of dash, above glove compartment. See Figure .
Time Control Unit Behind left kick panel. See Figure .
Traction Control System (TCS)
Control Unit Under left rear package tray. See Figure .
Throttle Control Module Under right side of dash, above glove compartment. See Figure .
4-Wheel Steering (HICAS) Control Unit Under right rear package tray. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.