Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1992 Infiniti G20 AutomaticFACTORY OEM SERVICE PROCEDURE
Maintenance Information
- Model Identification
- Maintenance Service Information
- Fuel Filter Service
- Air Bag Inspection
- Service Points
- Information Label Locations
- Service Labor Times
- Wheel & Tire Specifications
- Battery Specifications
- Cautions & Warnings
- Warranty Information
- Notes
- Basic New Car Limited Warranty
- Battery Limited Warranty
- Powertrain Warranty
- Perforation Warranty
- Parts & Accessories Limited Warranty
- Seat Belt Limited Warranty
- Emission Control System Defect Warranty (Except CALIFORNIA)
- Emission System Performance Warranty (Except CALIFORNIA)
- Emission System Performance Warranty (CALIFORNIA)
- Emission System Defect Warranty (CALIFORNIA)
- Fuses & Circuit Breakers
- Fuse & Relay Panel Location
- UNDERDASH Fuse Panel Identification (1991-93)
- Fusible Link & Engine Compartment Fuse I.D. (1991-93)
- Engine Compartment Relays (Right FENDERWELL - A/T Models)
- Engine Compartment Relays (Right FENDERWELL - M/T Models)
- Engine Compartment Relays (By Battery) (1991-93)
- UNDERDASH Fuse Panel Identification (1993.5-96)
- Fusible Link & Engine Compartment Fuse I.D. (1993.5-96)
- Engine Compartment Relays (Right FENDERWELL) (1993.5-96)
- Engine Compartment Relays (By Battery) (1993.5-96)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.