2023 Hyundai Tucson Plug-In Hybrid LimitedFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the console upper cover.

    (Refer to Body (Interior and Exterior) - " FLOOR CONSOLE ASSEMBLY REPAIR PROCEDURES  ") 

  3. Loosen the screw and then remove the electric shift button (A).
    G16173470Courtesy of HYUNDAI MOTOR AMERICA
  4. Loosen the screw and then remove the bezel (A) from the electric shift button.
    G16173471Courtesy of HYUNDAI MOTOR AMERICA
  5. Using a (-) driver and then remove the each position button.

    [P Button] 

    G16173472Courtesy of HYUNDAI MOTOR AMERICA

    [R Button] 

    G16173473Courtesy of HYUNDAI MOTOR AMERICA

    [N Button] 

    G16173474Courtesy of HYUNDAI MOTOR AMERICA

    [D Button] 

    G16173475Courtesy of HYUNDAI MOTOR AMERICA
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.