Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2021 Hyundai Venue SEFACTORY OEM SERVICE PROCEDURE
Repair Procedures: Installation
- To install, reverse the removal procedures.CAUTION:
- New shift lever assembly is mounted in the 4th fixing pin. After installation, remove the neutral fixing pin.
- Check operating of lever of transaxle side when operating shift lever after assembly. (1~6, R)
- If there is sticky feel, adjust the control cable length again. (Refer to Manual Transaxle Control System - "CONTROL CABLE ")
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.