2021 Hyundai Venue SEFACTORY OEM SERVICE PROCEDURE

Repair Procedures: Removal

  1. Turn OFF ignition switch and then disconnect the battery negative (-) cable.
  2. Remove the shift lever knob & boots (A).
    G14694852Courtesy of HYUNDAI MOTOR AMERICA
  3. Remove the floor console assembly.

    (Refer to Body - "FLOOR CONSOLE ")

  4. Separate the clip (A) of fixed wiring.
  5. Disconnect the connector (B).
    G14694853Courtesy of HYUNDAI MOTOR AMERICA
  6. Separate the air duct (A) from the both side.
    G14694854Courtesy of HYUNDAI MOTOR AMERICA
  7. Separate the shift cable.
    1. Remove the snap pin (A).
    2. Separate the shift cable (B).
      G14694855Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • When installing the shift cable, Lug (A) must assemble upward.
      G14694856Courtesy of HYUNDAI MOTOR AMERICA
    • Bending area (A) must assemble the front.
      G14694857Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the bolts and then shift lever assembly (A).

    Tightening torque: 

    8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb-ft)

    G14694858Courtesy of HYUNDAI MOTOR AMERICA
Chapter Navigation
Return to Chapter: Repair Procedures
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.